Hi,
Did anyone get skype connect working successfully for incoming calls ?
I have set it up as per the skype instructions, the trunk registers ok and my skype business account shows as online. Incoming calls do not ring but just hang up after 2 seconds.
Regards
Thr trunk registers , but on outgoing calls there response is being sent to 5060 port where as the account needs it at 5062 .
Though i am not 100 % sure this would be case but for sure it would have something to do with responses being sent out by pbxes not reaching the port skype want it to .
Have your tried it on some softphone or ATA and have any issues there ? .. if it works there then the issue has to be with response messages . Else you need to check with skype connect .
Hi,
I'm not sure if its the same issue or not.
My incoming skype connect calls show in the call monitor but always hangup at exactly the same point in the system log.
Jul 19 11:53:14 VERBOSE[36204] logger.c: Found description format telephone-event
Jul 19 11:53:14 VERBOSE[36204] logger.c: Capabilities: us - 0x161e (gsm|ulaw|alaw|g726|speex|ilbc|g722), peer - audio=0x10c (ulaw|alaw|g729)/video=0x0 (nothing), combined - 0xc (ulaw|alaw)
Jul 19 11:53:14 VERBOSE[36204] logger.c: Non-codec capabilities: us - 0x1 (telephone-event), peer - 0x1 (telephone-event), combined - 0x1 (telephone-event)
Jul 19 11:53:14 VERBOSE[105233] logger.c: We're at 188.40.65.170 port 42552
Jul 19 11:53:14 VERBOSE[105233] logger.c: Video is at 188.40.65.170 port 38854
Jul 19 11:53:14 VERBOSE[105233] logger.c: Adding codec 0x4 (ulaw) to SDP
Jul 19 11:53:14 VERBOSE[105233] logger.c: Adding codec 0x8 (alaw) to SDP
Jul 19 11:53:14 VERBOSE[105233] logger.c: Adding non-codec 0x1 (telephone-event) to SDP
Jul 19 11:53:15 VERBOSE[105233] chan_sip.c: Hangup call
Well i guess it is same issue , as even here if i redirect calls directly , the phone rings but drops off after few rings , as the switch does not receive response back from pbxes on right port and thereby doesnot detect call as connected .
Well iptel would be best guy to tell if issues are actually similar.
Hi,
Thanks for this. Can you clarify which Username.
When setting up Skype Connect you have a Skype Manager username, a Sip profile name and a Business account name.
Regards
EDIT: All working ok now thanks. Inbound Routing trunk is set to the Sip username of the skype connect trunk.
This post has been edited 1 time(s), it was last edited by tel on 23.07.2012 at 22:34.