RE: Multiple DID on the same trunk (MyDivert) |
|
I believe what VOI means is the following:
* * *
1. Check with your trunk provider IF he allows
multiple log-in with same credentials (or even with
different credentials) and IF he can associate
different DID to different log-in sessions
2. Register several trunks on PBXes, with the same provider
one trunk per DID. Use different trunk names on PBXes
3. Check if the in-bound trunk mechanism on PBXes
recognize the incoming trunk based on the name
you provided at above step #2. If so
then you can now set up your in-bound rule based
on the trunk name which will allow you to
distinguish between different DIDs
I had the same problem and, to handle it, since my DID
provider did not allow the option I described at above step 1, I had to create several accounts, thus several trunks, one per DID, to solve this issue.
Therefore, it is not possible to create an inbound rule, one per DID, as VOI says, but it is possible to create an inbound rule, one per TRUNK, and if you associate only one DID to each TRUNK then you can handle this.
Hope this helps.
This post has been edited 3 time(s), it was last edited by rda on 24.03.2015 at 10:00.
|